1. Before using the check:
Before starting the first moving parts should be the fully gives lubricating oil, and should be inspected.
Control the moving workbench flow control rod, must be in the closed position (vertical position).
The grinding wheel is good or not without break, gravamen.
Check the hand tools, small part and other unnecessary items are really away from the table.
On the total power switch, view operation power whether light lamp.

2. Drive steps:
Operation method choice: according to operation on the grinding machine can choose to need, manual and automatic operation, choose NiuPan appliances
The operating choose button for automatic graphics marked position pull, can use automatic operation.
Manual operation:
Will choose button in manual operation graphics position.
Put the electric magnetic separation button in magnetic pull suction graphics position.
Will the grinding wheel button and operation.
The hydraulic motor start button and.
The moving workbench the clockwise adjustment to appropriate location.
Shook with move the handwheel (before and after, up, or down) can be manual operation grind.
Automatic operation:
Will operate in automatic graphics location choice button.
According to the manual or more of the operation.

On, under automatically feed control grinding:
Selected switch in cutting PingMo rotating grinding graphics position, and then press, automatic into the starting button to,
Then, when the worktable or so movement to the left, right, grinding wheel will be down into to, when choosing PingMo switch
In grinding plane position, and then press, automatic into the starting button to carriage is to be in front or back
The party, grinding wheel will be down into give, will choose to turn the switch in O position, the grinding wheel will stop
In down.
Down into the ring to set instructions setting in advance.

3. Use should note:
Operation grinding:
To make the grinding wheel, grinding wheel operation with the direction of the arrow mark is correct.
The workpiece firmly in the electromagnetic absorption clamp the, such as the too small must use precision jaw clamped operation.
Under the material to grind down into to degrees.
Grinding size the area is large, deep need to open the cooling water scale at this time.
Barring special circumstances, do not choose to operate in automatic grinding.

Four. Stop steps:
Every noon a rest, from work or stop operation, should make grinding machine in safe stop state.
Homework operation: the workbench the mobile flow control stem from right to push, make workbench stop in the center position.
Stop hydraulic motor: next stop hydraulic motor and button.
Stop electromagnetic clip suck magnetic: will the electromagnetic clip in revolt button pull off magnetic position, make it to take off the magnetic.
Stop cooling water pumping motor: he stopped pumping motor button.
Stop grinding wheel motors: next stop and grinding wheel motor button.
Cut off power supply: the power on held, and will always down the power switch.

Five. After use note:
After parking, each part workbench the wiped clean.
The grinding wheel must keep dry without water.

6. Troubleshooting:
The grinding wheel uneven nap:
Will the diamond dressing knife on disk, open suction magnetic absorb.
Drill ShiXiu knife with grinding wheel to the right JiaoJiao (about 5 degrees).
Diamond dressing grinding wheel from the central began to repair.
Under the main motor runs and grinding wheel button.
Shake before and after the handwheel.
Every time the depth about 0.01 MM in dressing for, make till.
Check the grinding wheel uneven reason, whether the right choice grinding wheel and the appropriate action, and be ruled out.
Cooling water switch on no water:
Pumping motor nozzle have sundry blocked dimension, it should remove debris.
Water level is not enough, it should be add water to water tank.